不同類型的產品需要單獨的結構模具，模具成本通常不便宜，進一步增加了成本。對於訂單量較小的小型企業來說，模具費的成本負擔可能會很大，因此不切實際。理論上，防水外殼應該是防漏的，就像潛水艇一樣。不幸的是，小型、普通的外殼往往無法達到真正的「防水」效果。例如，在濕度較高的地區，如南方地區，水蒸氣可能會透過外殼的裂縫滲透。最壞的情況是外殼的連接處因晝夜溫差較大而變形，讓水蒸氣進入內部，對電路板造成腐蝕。在鹽霧盛行的沿海地區尤其如此。
There isn't any activation stage a consumer can or has got to complete. It's dealt with by BandLab Assistant because it operates the Cakewalk installer.
▼作conformal coating時也可以使用不殘膠的貼紙黏貼於一些不可以噴塗到的零件。
缺點是塗布時容易因為塗布的技巧熟練度或疲勞度而造成塗布不均勻或塗布不穩定，另外也要留意毛刷掉毛的問題。零件底部被較難塗布到。
It in all probability wouldn't be also difficult to locate on our have, but I'm no previously mentioned allowing someone do the investigate for me :)
案例分析：例如，在製造開關電源時，設備內部有一塊電路板。從外面看，只需開模具製作塑膠外殼即可實現防水防潮。外殼可選用緻密材料，連接處可採用防水橡膠圈密封。這可以有效阻擋灰塵、水和類似元素。然而，用熱熔膠密封外殼可能會導致以後的維護問題。
There are 2 contradictory sets of Recommendations on the Bandlab web page, neither of which seems to operate.
A：一般而言，導通問題多半源於未接通前噴塗過量或過厚，導致接點無法順利連通。
Very first time I cracked up for the message and didn't read through it in entire. Just checked out it once again, and the total concept is as follows:
I am somewhat upset. Not complaining, I see what they try to perform 電路板防潮 and It is all very good In general.,, just actually not nearly anything exiting for those of us who have already got this. Fantastic for The remainder who now get it all at no cost.
Now I should uninstall all all over again and wait for hrs to obtain. Why Is that this not posted in with a sticky. If it no cost why all this stick with it. Ridiculous.
知乎，让每一次点击都充满意义 —— 欢迎来到知乎，发现问题背后的世界。
Very well I am now logged in to BandLab Assistant and It truly is displaying "Up-to-date". The only real obtainable possibilities are "Uninstall" and "Learn more". I tried logging out As well as in once more but that didn't change something.
I assumed Tungsten was the default, at least that it was set this way following I put in CbC and prior to copying in excess of a topic I designed for SONAR. In CbB the Tungsten concept has the new dim PRV.